Laren piling: Mini Piling

By: Larsen Piling  05/12/2011
Keywords: mini piling, Piling Equipment

Mini Piling is a low vibration restricted access system. Ideally suited for small extensions or refurbishment work. (5-30T)

Why Mini Pile?

  • Unsuitable ground conditions for standard foundations
  • Risk of undermining or damaging existing services and/or foundations
  • Restricted access for piling equipment
  • Minimise cost of installing a hardcore base for the piling rig
  • Low headroom situation
  • Eliminates fumes in confined areas, if using a remote powered rig
  • When a low vibration solution is required
  • Minimal noise levels
  • Minimal disruption
  • Ideal for small to medium sized jobs
  • Upgrading foundations/floors for increased loadings
  • No spoil created

Why Use Larsen Foundations

Cost effective & efficient installation of mini piles by fully certified Piling Operatives to latest codes and standards

  • Conveniently based - Belfast and Dublin
  • Minimum access required from 600mm wide
  • Low vibrations solutions
  • Fast and efficient service
  • Full complement of rigs for most situations

Keywords: mini piling, Piling Equipment

Other products and services from Larsen Piling


Laren piling: Underpinning

Timber floors can be replaced with solid concrete floors which can be left at a reduced level to facilitate the installation of insulation or the provision of an under floor heating system. Traditional Underpinning stabilises the existing walls by excavating beneath the existing foundations in a ‘Hit & Miss’ fashion, to a depth where firm load bearing strata exists.


Laren piling: Grouted Ductile Cast Iron

The pile is significantly smaller in diameter than a similar capacity CFA pile, as such there is less new material used in the construction of the pile and a minimal amount of concrete used in the pile forming process. Cost effective & efficient installation of piles by fully certified Piling Operatives to latest codes and standards. Rig is ideal for very soft ground condition being small and light weight.


Laren piling: Helical Screw Piles

Screw Piles are composite end-bearing/friction piles well suited for resistance to compression of tension loads, in poor soil conditions by transferring load to to high end bearing capacity helical plates. This system can include lifting brackets to enable settled buildings to be returned to their original line and level. It consists of a steel anchor with a 100 to 250mm grout column around the shaft above the helical plates.


Laren piling: Grundomat

Cost effective installation of piled foundations for conservatories, sun lounges & single room extensions to engineer approved designs. Mini Piled Foundations for Conservatories, Sun Lounges & Single Room Extensions. Unsuitable ground conditions for standard foundations. Air driven piling system with no piling rig.